Nodes of different colours represent the following:
Solid arrows point from a parent (sub)module to the submodule which is descended from it. Dashed arrows point from a module being used to the module or program unit using it. Where possible, edges connecting nodes are given different colours to make them easier to distinguish in large graphs.
Nodes of different colours represent the following:
Solid arrows point from a procedure to one which it calls. Dashed arrows point from an interface to procedures which implement that interface. This could include the module procedures in a generic interface or the implementation in a submodule of an interface in a parent module. Where possible, edges connecting nodes are given different colours to make them easier to distinguish in large graphs.
Nodes of different colours represent the following:
Solid arrows point from a procedure to one which it calls. Dashed arrows point from an interface to procedures which implement that interface. This could include the module procedures in a generic interface or the implementation in a submodule of an interface in a parent module. Where possible, edges connecting nodes are given different colours to make them easier to distinguish in large graphs.
SUBROUTINE AddTOCZoneLoadComponentTable
! SUBROUTINE INFORMATION:
! AUTHOR Jason Glazer
! DATE WRITTEN March 2012
! MODIFIED na
! RE-ENGINEERED na
! PURPOSE OF THIS SUBROUTINE:
! Add the table of contents entries for the Zone heat transfer
! summary report.
! METHODOLOGY EMPLOYED:
! Call the AddTOCEntry routine for each zone.
! REFERENCES:
! na
! USE STATEMENTS:
! na
USE DataHeatBalance, ONLY: Zone
USE DataZoneEquipment, ONLY: ZoneEquipConfig
USE DataGlobals, ONLY: CompLoadReportIsReq
IMPLICIT NONE
! SUBROUTINE ARGUMENT DEFINITIONS:
! na
! SUBROUTINE PARAMETER DEFINITIONS:
! na
! INTERFACE BLOCK SPECIFICATIONS:
! na
! DERIVED TYPE DEFINITIONS:
! na
! SUBROUTINE LOCAL VARIABLE DECLARATIONS:
INTEGER :: iZone
IF (displayZoneComponentLoadSummary .AND. CompLoadReportIsReq) THEN
DO iZone = 1, NumOfZones
IF (.not. ZoneEquipConfig(iZone)%IsControlled) CYCLE
CALL AddTOCEntry('Zone Component Load Summary',Zone(iZone)%Name)
END DO
END IF
END SUBROUTINE AddTOCZoneLoadComponentTable