Nodes of different colours represent the following:
Solid arrows point from a parent (sub)module to the submodule which is descended from it. Dashed arrows point from a module being used to the module or program unit using it. Where possible, edges connecting nodes are given different colours to make them easier to distinguish in large graphs.
Nodes of different colours represent the following:
Solid arrows point from a procedure to one which it calls. Dashed arrows point from an interface to procedures which implement that interface. This could include the module procedures in a generic interface or the implementation in a submodule of an interface in a parent module. Where possible, edges connecting nodes are given different colours to make them easier to distinguish in large graphs.
Nodes of different colours represent the following:
Solid arrows point from a procedure to one which it calls. Dashed arrows point from an interface to procedures which implement that interface. This could include the module procedures in a generic interface or the implementation in a submodule of an interface in a parent module. Where possible, edges connecting nodes are given different colours to make them easier to distinguish in large graphs.
SUBROUTINE SetupSurfaceOutdoorBoundaryConditionActuators
! SUBROUTINE INFORMATION:
! AUTHOR B. Griffith
! DATE WRITTEN May 2013
! MODIFIED na
! RE-ENGINEERED na
! PURPOSE OF THIS SUBROUTINE:
! setup EMS actuators for outside boundary conditions by surface
! METHODOLOGY EMPLOYED:
! loop through all surfaces, cycle if not heat transfer or outdoors BC
! REFERENCES:
! na
! USE STATEMENTS:
USE DataInterfaces, ONLY: SetupEMSActuator
USE DataSurfaces, ONLY: Surface, TotSurfaces, ExternalEnvironment
IMPLICIT NONE ! Enforce explicit typing of all variables in this routine
! SUBROUTINE ARGUMENT DEFINITIONS:
! na
! SUBROUTINE PARAMETER DEFINITIONS:
! na
! INTERFACE BLOCK SPECIFICATIONS:
! na
! DERIVED TYPE DEFINITIONS:
! na
! SUBROUTINE LOCAL VARIABLE DECLARATIONS:
INTEGER :: SurfNum ! local loop index.
DO SurfNum = 1, TotSurfaces
IF (.NOT. Surface(SurfNum)%HeatTransSurf) CYCLE
IF (.NOT. Surface(SurfNum)%ExtBoundCond == ExternalEnvironment) CYCLE
CALL SetupEMSActuator('Surface', Surface(SurfNum)%Name, &
'Outdoor Air Dryblub Temperature', '[C]', &
Surface(SurfNum)%OutDryBulbTempEMSOverrideOn, &
Surface(SurfNum)%OutDryBulbTempEMSOverrideValue)
CALL SetupEMSActuator('Surface', Surface(SurfNum)%Name, &
'Outdoor Air Wetblub Temperature', '[C]', &
Surface(SurfNum)%OutWetBulbTempEMSOverrideOn, &
Surface(SurfNum)%OutWetBulbTempEMSOverrideValue)
IF (Surface(SurfNum)%ExtWind) THEN
CALL SetupEMSActuator('Surface', Surface(SurfNum)%Name, &
'Outdoor Air Wind Speed', '[m/s]', &
Surface(SurfNum)%WindSpeedEMSOverrideOn, &
Surface(SurfNum)%WindSpeedEMSOverrideValue)
ENDIF
ENDDO
RETURN
END SUBROUTINE SetupSurfaceOutdoorBoundaryConditionActuators